Decontamination
log 2 – 3Microbial reduction that makes the treated environment or object safe and harmless.
The principle
Flashes of white light destroymold spores
- 01
A flash, not a chemical compound
In a few milliseconds, a xenon lamp releases a burst of white light 100,000 times more intense than the solar spectrum. It is a flash, not a chemical compound.
- 02
Contactless
The treatment acts at a distance on every exposed surface: no wiping, no consumables, no manual rework.
- 03
Residue-free
No water, no peroxide, no toxic gas. Xenon is chemically inert, unlike mercury UV lamps.
Xenon lamp · millisecond flash
A full spectrum, from 180 to 1100 nanometers
The spectrum in 4 ranges
Where a conventional UV lamp acts on a single wavelength, pulsed light covers the whole spectrum. Decontamination stays effective on the most resistant germs: mold spores, bacterial spores, bacteria, pathogens, viruses.
180 nm1100 nm
Replication stops for good
Three moments, a single light pulse: from crossing the cell wall to the definitive halt of replication.
01Pulse
The flash crosses the wall
Photon energy penetrates the micro-organism's membrane in a fraction of a second. No contact, no chemicals, no waiting time.
02Break
The double strand is broken
The process instantly destroys the DNA double strand, not just its ability to express itself. The genetic structure is physically disorganized.
03Inactivation
Replication stops
No repair, no regrowth: the germ is permanently inactivated. The effect is irreversible, with no lag phase.
Three levels of action
Decontaminate, disinfect, sterilize
The level reached depends on the surface, how hard it is for light to reach it and how clean it is to begin with.
Disinfection
log 4 – 5A process eliminating all unwanted micro-organisms without reaching zero. The goal is to remove infection risk.
Sterilization
log 6Lasting destruction of all micro-organisms, down to a survival probability below 1 in a million. Note: you can only sterilize what is clean and dry.
In the field
Simple, safe, immediately usable
A 10-minute cycle
A complete room treatment takes about ten minutes, between two production runs.
No drying time
No fogging, no extended airing: the room is immediately usable again.
Zero consumables
No chemical refill to store, dose or dispose of after use.
3 to 6 log of microbial reduction
Let's look together at the level achievable on your surfaces, your volumes and your production constraints.